Dalkau Services

Why air conditioning can fail in winter — and how to prevent it

Reversible air conditioning is placed under heavy strain in the French Alps. These are the real causes, mistakes to avoid and safe steps before calling an engineer.

The problem: winter air conditioning in the mountains

Cold, humidity, snow and rapid heating of an empty second home combine to create heavy defrost cycles, reduced output and mechanical faults.

A simple technical explanation

1. Frost and defrosting

Below about 5°C, especially in damp air, ice forms on the outdoor exchanger.

The system briefly reverses to melt it. Excessive or ineffective cycles reduce heat and may trigger protection.

2. Snow obstruction

Snow around the outdoor unit blocks airflow, reduces heat transfer and can stop the system.

3. Cold restart after a long absence

A second home at 3–4°C should not be pushed immediately to 22°C.

Maximum output with very cold compressor oil creates avoidable mechanical stress.

4. Cold-weather physics

As outdoor temperature falls, less heat is available. Standard equipment loses capacity and uses more electricity if not sized for Alpine winters.

Common mistakes

  • Selecting 22°C boost on arrival.
  • Leaving snow around the outdoor unit.
  • Postponing servicing until a winter fault.
  • Repeatedly restarting a faulted unit.
  • Using lowland equipment or positioning the unit too low for snow and drainage.

Solutions: correct installation, servicing and safe action

Reliable mountain heating depends on suitable equipment and serious servicing.

1. Mountain-ready installation

Choose cold-climate inverter equipment with useful output around −15°C.

Mount the outdoor unit clear of snow with space for defrost water.

2. Professional pre-winter servicing

Check the refrigerant circuit, exchangers, defrost controls and condensate drainage before winter.

3. If a fault still occurs

Stop rather than forcing the unit.

Remove loose snow without hot water or sharp tools.

One ten-minute electrical reset may clear a transient code.

Restart at 16–17°C and increase gradually.

Call a local installer if the fault remains.